Aiwa NSX-A555 User Manual download pdf (Page 19)

The unit can be turned on at a specified time every day with the

built-in timer.

Preparation

Make sure the clock is set correctly.

Press one of the function buttons to select a

source.

● If TUNER BAND is pressed, the band cannot be selected in

this step.

Press TIMER

repeatedly until @ appears on the

display.

When using the remote control, press TIMER while pressing

Sf-fll=-r.

Time and audio source name flash alternately.

Within 6 seconds, turn MULTI JOG to designate

the timer-on time, then press ENTER or H1.

Turning MULTI JOG changes both the hour and the minute.

+ or - is also available instead of MULTI JOG. Holding

these buttons down will vary the time rapidly.

Within 4 seconds, turn MULTI JOG to select the

duration for the timer-activated period.

The duration can be set between 5 and 240 minutes in 5-

minute steps.

- or - is also available instead of MULTI JOG.

Adjust the volume.

The source sound will play at the volume level set in this step

when the power is turned on by the timer.

If the volume level is set to 21 or higher, however, it will

J#%,

-9

automatically be set to 20 when the power is turned on, .~. .~%

g%!

Prepare the source.

:$*$

To listen to a CD, load the disc to be played first on tray 1.

f$$$

To listen to a tape, insert the tape into deck 1 or 2.

a-y

To listen to the radio, tune in to a station.

Press POWER to turn off the power.

When the timer-on time is reached; the unit turns on and

begins play with the selected source,

You can change the source that was selected in step 1 by

pressing one of the function buttons before pressing ENTER or

II in step 3.

To check the timer setting

Press TIMER.

The selected source, the timer-on time, and the duration for the

timer-activated period will be displayed for 4 seconds.

To change any of the previous setting

Carry out from step 1.

However, if you do not change the timer-on time, in step 3 just

press ENTER twice and continue from step 4.

To cancel the timer standby mode temporarily

Press TIMER repeatedly so that @ disappears.

To restore the timer standby mode, press again to display ~).

Using the unit while the timer is set

You can use the unit normally after setting the timer.

❑

Before turning off the power, ‘carry out step 5 and 6.

● Timer playback and timer recording will not begin unless the

power is turned off.

● Connected equipment cannot be turned on and off by the built-

in timer of this unit. Use an external timer.

Timer recording is applicable for TUNER and VI DEO/AUX (with

an external timer) sources only.

Press either TUNER BAND or VIDEO/AUX to select a source,

then press TIMER repeatedly until @ flashes on the display.

Within 6 seconds, carry out the steps of “SETTING THE TIMER

from step 3 and insert the tape to be recorded on into deck 2

after step 6.

● When the power-economizing mode (page 7) has been turned

on, the timer recording volume level will be O (minimum level).

c You cannot use the timer function to record from a CD or tape.

The duration will be automatically set after 4 seconds. It will

also be set if ENTER or II is pressed within 4 seconds after

step 4.

ENGLISH 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

Comments to this Manuals

No comments

Aiwa NSX-A555 User Manual Page 19

Comments to this Manuals

Related products and manuals for Cassette players Aiwa NSX-A555