Aiwa JAX-S5 Service Manual Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 72
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
CX-JN10
2323
6-4. NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Printed Wiring Board:
X : parts extracted from the component side.
Y : parts extracted from the conductor side.
x : parts mounted on the conductor side.
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Indication of transistor.
C
B
These are omitted.
E
Q
B
These are omitted.
CE
Q
Note on Schematic Diagram:
All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
All resistors are in and
1
/
4
W or less unless otherwise
specified.
2 : nonflammable resistor.
5 : fusible resistor.
C : panel designation.
A : B+ Line.
B : B– Line.
Voltages and waveforms are dc with respect to ground
under no-signal conditions.
– BD Section –
no mark : CD PLAY
– Other Sections –
no mark : FM
: Impossible to measure
Voltages are taken with a VOM (Input impedance 10 M).
Voltage variations may be noted due to normal produc-
tion tolerances.
Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
Circled numbers refer to waveforms.
Signal path.
F : TUNER (FM/AM)
E : TAPE PLAY (DECK-A)
d : TAPE PLAY (DECK-B)
G : REC
J : CD PLAY
L : AUX IN
N : MIC INPUT
Abbreviation
AUS: Australian model
E51 : Chilean and Peluvian models
EA : Saudi Arabia model
SP : Singapore model
TW : Taiwan model
Circuit Boards Location
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
CD KEY board
SENSOR board
BD board
MOTOR (TB) board
DRIVER board
MOTOR (LD) board
SW board
KEY board
PT board
HP board
PANEL board
MAIN board
TUNER PACK
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 71 72

Comments to this Manuals

No comments