Aiwa CA-DW935M Operations Instructions download pdf (Page 4)

POWER SUPPLY

CONNECTIONS

USING ON AC HOUSE CURRENT

Connect the AC cord as illustrated below.

0 to the AC inlet of the unit

+ 0 to an AC outlet

CAUTION

Use only the supplied AC cord. Use with other cords may result

in the risk of fire.

USING ON BATTERIES

Open the lid of the battery compartment on the rear and insert

eight R20 (size D) batteries, not supplied, as illustrated below.

Then close the lid.

,----1 .-ml

When disconnecting the AC cord or removing the batteries, be

sure to turn the unit off (make sure the OPE/BATT indicator is

off)

switch from AC power supply to battery power supply,

disconnect the AC cord from the AC inlet.

Batteries wear excessively when the cord is connected.

The batteries need to be replaced when:

The OPE/BATT indicator becomes dim, the tape speed slows

down, volume decreases, or sound is distorted during operation.

Notes on batteries

To avoid damage from leakage or explosion, observe the

following:

● Insert the batteries with the 0 and O marks correctly aligned.

- Do not mix different types of batteries or old batteries with new

ones.

● Never recharge the batteries, apply heat to them or take them

apart.

● Remove dead batteries.

If liquid leaks from the batteries, wipe thoroughly to remove.

IMPORTANT

● Make sure that the AC cord is disconnected and batteries are

removed before connecting speakers.

“ Connect only the supplied speakers.

Position

the speakers.

To couple with the speakers, slide each speaker down into

the guide brackets on the center unit until the height is level

with the unit.

separate the unit from the speakers, slide the speakers

up and off, while pressing the speaker release knob.

Connect the speakers.

Connect the right speaker cord to the R terminals, and the

left speaker cord to the L terminals.

Connect the speaker cord with the white broken line to 0

and the other cord to O.

Sound signals can be input to this unit through the AUX/VIDEO

jacks.

Use a cable with RCA phono plugs (not supplied) to connect the

external equipment.

Connect the red plug to the R jack, and the white plug to the L

jack.

To listen to the external source

Press the AUX button and play the equipment.

Refer also to the operating instructions of the connected

equipment for details.

4 ENGLISH

1 2 3 4 5 6 7 8 9 ... 51 52

Comments to this Manuals

No comments

Aiwa CA-DW935M Operations Instructions Page 4

Comments to this Manuals

Related products and manuals for Cassette players Aiwa CA-DW935M